Has anyone had good/bad experiences with particular PCB-mount thermocouples?

I need to design a circuit board with a connector I can plug a standard thermocouple connector into. And, I am aware that when you connect thermocouple wires to copper traces, you create junctions of dissimilar metals that can cause errors if the junctions are at different temperatures.

PCB Assembly, PCB Design
December 12, 2023

The most important part of how/where/when to connect a thermocouple is to measure the temperature as close as possible to the bimetallic joint.

Firstly, feed that temperature into your uP, and then you can use software to perform the CJC compensation. Do not forget to use the known polynomials (or simplified linearized equations for smaller ranges) for converting your ADC value into temperature.

In the past, we have got a big chunk of aluminum and performed wire to wire terminations around it and installed a LM35 for temperature measurement. This was performed off the PCB. You can freely do it with connections n stuff on the PCB as long as you are able to measure the temperature as close as possible to the bimetalic junction.

So to keep the distance as short as possible. And consider using screw terminals and mount the LM35 right near the screw terminals themselves for the most accurate reading.

If you really want to use a connector, try DB9 with the metal back shell – cheap as chips. Being metal will conduct heat well for accurate measurement of the back shell temperature. Last, use male pins on the PCB.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Can I use normal PCB, such as office fan PCB, in mining fan?

The price of office fan PCB is pretty a lot than the mining type. After all it is inserted inside, can I use office fan PCB to in mining fan?

Oliver Smith October 17, 2023

How do you handle defective PCB with flux residue?

We feel a little disappointed about the batch of goods from oversea suppliers. Some of PCB has flux residue. How should I handle them?

Oliver Smith October 24, 2023

How does PCB manufacturer work for double sided SMT assembly with BGA’s?

How does a conventional board house deal with the issue of reflow during PCB component assembly with BGA’s on both sides of the board?
Are two different solders used (like regular lead free SAC305 and a low temp?)

Oliver Smith November 6, 2023