It is expensive because component-level service is not done by the TV manufacturer. The costly PCB will be replaced by a service technician even if the failure may be due to a single defective component in the PCB.
It will take technical expertise and special tools to troubleshoot and replace the SMD IC’s and components. As most of the servicing is done at the field(Customer locations) it is easier for the service technician to replace the PCB with a screwdriver (and soldering iron if needed).
The consumer will spend more on this deal but with less down-time. During the era of CRT TV’s, most of the servicing was done at the component level.
Lire la suite: Comment réparer les circuits imprimés?
#Assemblage de PCB #Consommation d'électronique
While most people focus on the components and copper traces that make up PCBs, there's…
The right type of PCB material can make or break the performance of your electronics project.…
BGA reballing emerges as a critical repair technique for modern electronic devices. Aujourd'hui, appareils électroniques…
Do you know what PCB stiffeners are? They are widely used in flex and rigid-flex…
Dans le processus de fabrication des PCB, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…