If you want to meet CE requirements for noise immunity and emissions, a two-layer board would help a lot.
En général, there is no problem with putting components on both sides of the board, in the same place. If you had a two (or more) panneau de couches, you’d probably want to put a ground or power plane between them. pourtant, you can’t do that with a single-layer board. So you should watch out for a fast digital chip interfering with an analog circuit. It would be inadvisable.
Par exemple, put a microcontroller on one side and a high input impedance buffer on the other. But putting decoupling caps opposite the chip is probably a good plan.
Lire la suite: Fabrication d'électronique de télécommunication
#Conception de PCB
While most people focus on the components and copper traces that make up PCBs, there's…
The right type of PCB material can make or break the performance of your electronics project.…
BGA reballing emerges as a critical repair technique for modern electronic devices. Aujourd'hui, appareils électroniques…
Do you know what PCB stiffeners are? They are widely used in flex and rigid-flex…
Dans le processus de fabrication des PCB, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…