d'abord, check whether your PCB is high voltage. En général, high voltage is defined as starting at 1000V.
Cela étant dit, there is absolutely nothing wrong in general with using surface-mount parts in a device running at these voltages, so long as the parts you are using are rated for voltages you are using them at. Keep in mind as well that you do not need to make a single decision between SMT and through-hole parts. You can mix and match both within a single design.
#Conception de PCB #Assemblage de PCB
While most people focus on the components and copper traces that make up PCBs, there's…
The right type of PCB material can make or break the performance of your electronics project.…
BGA reballing emerges as a critical repair technique for modern electronic devices. Aujourd'hui, appareils électroniques…
Do you know what PCB stiffeners are? They are widely used in flex and rigid-flex…
Dans le processus de fabrication des PCB, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…