We use cookies to help you navigate efficiently and perform certain functions. You will find detailed information about all cookies under each consent category below.
The cookies that are categorized as "Necessary" are stored on your browser as they are essential for enabling the basic functionalities of the site. ...
Necessary cookies are required to enable the basic features of this site, such as providing secure log-in or adjusting your consent preferences. These cookies do not store any personally identifiable data.
Functional cookies help perform certain functionalities like sharing the content of the website on social media platforms, collecting feedback, and other third-party features.
Analytical cookies are used to understand how visitors interact with the website. These cookies help provide information on metrics such as the number of visitors, bounce rate, traffic source, etc.
Performance cookies are used to understand and analyze the key performance indexes of the website which helps in delivering a better user experience for the visitors.
Advertisement cookies are used to provide visitors with customized advertisements based on the pages you visited previously and to analyze the effectiveness of the ad campaigns.
You can just put plated half holes on the edge of the small board and then solder it directly to the large board. This skips having a connector all-together. Many board manufacturers can do this.
Lee mas: PCB Design and Layout Service
#Diseño de PCB
Reciba el prototipo de PCB del proveedor. Y ver una marca CR en el tablero.. Qué significa? ¿Está relacionado con el control de calidad??
Creo que he oído hablar de colocar una vía enchufada justo al lado de una almohadilla mecánica para que la placa sea más fuerte allí.. Pero no estoy seguro de cuáles son las implicaciones de poner una vía en el pad.?
¿Existe una regla general sobre la cantidad de espacio libre que se debe agregar a los componentes con orificios pasantes?’ agujeros para permitir que encajen fácilmente? Por ejemplo, si tengo un componente con un diámetro de pasador de 1 mm, ¿Cuál debe ser el diámetro de los agujeros para sus pastillas??
Mercados
tarjeta de circuito impreso
Contáctenos
Copyright ©2025 MOKO Technology | Su socio de confianza de EMS Número de ICP de Guangdong 15085690
