primeramente, check whether your PCB is high voltage. Generalmente hablando, high voltage is defined as starting at 1000V.
Habiendo dicho eso, there is absolutely nothing wrong in general with using surface-mount parts in a device running at these voltages, so long as the parts you are using are rated for voltages you are using them at. Keep in mind as well that you do not need to make a single decision between SMT and through-hole parts. You can mix and match both within a single design.
#PCB Design #PCB Assembly
PCB copper foil is one of the most critical materials in the printed circuit board…
Shenzhen, China - febrero 11, 2025 - Tecnología MOKO, a leading global electronics manufacturing service…
While most people focus on the components and copper traces that make up PCBs, there's…
The right type of PCB material can make or break the performance of your electronics project.…
BGA reballing emerges as a critical repair technique for modern electronic devices. Hoy en día, dispositivos electrónicos…
Do you know what PCB stiffeners are? They are widely used in flex and rigid-flex…