Ja.
The solder reflow heat mass is significantly greater in assembly line.
| Make by Yourself | Versammlung L.ine |
| You may need some forced air for ramp-down and a thermal couple probe to “profile” a bare board to match the LED recommended ramp rates, peak liquidus dwell and cooling rates to prevent solder stress failures. If you do not have thermal couples , estimate the liquidus point when a tiny blob of solder melts and the duration it is melted. and your overall profile time from the datasheet. Avoid too slow and too fast as the wire bond may shear inside. | Assembly line process engineers do this with a thermally protected data collection module. It slow down the conveyor speeds to absorb the higher heat mass as well as accelerate the temperature rise in the number of zones in their control. Too slow is a reliability issue for LEDs and the overall time to ramp up and down must not be exceeded for this reason. |
Weiterlesen: Aluminiumplatine
#Leiterplattenmontage
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…
Printed Circuit Board design is one of the most significant processes in electronics production. Deciding…
Die von uns verwendeten elektronischen Geräte unterliegen ständigen Veränderungen und Verbesserungen. Sie werden kleiner und funktioneller,…
Die Leiterplattenbestückung ist ein äußerst komplizierter Prozess, Dabei kommt es immer auf Genauigkeit an. Even…
Es ist wichtig sicherzustellen, dass ein PCB-Design zuverlässig ist, da es keine Designfehler gibt,…
Beim Entwurf der Leiterplatte, a high level of concentration is given towards PCB signal…