Wie viel größer sollte ein durchkontaktiertes Loch sein als der Leitungsdurchmesser, um eine gute Lotbenetzung zu erreichen??

I don’t think you should depend on the holes to locate the part when tolerances are important. Ich finde 10-15 mils is good solution(in metric 0.25 to 0.4mm).

Make up a jig to hold the parts in the proper location while they are being soldered. It can be fancy for wave soldering or something simple that holds the parts while being hand soldered (perhaps fashioned from the mating part such as the punched chassis).

Round pins are a particular hassle if you call it too close- at least with square or rectangular pins you can skive off some plating inside the holes at the corners of the pin and still force the pin in. If you insist on the using the holes, maybe make the peg round and the hole square (call out slot-drilled square holes in the PCB).

Weiterlesen: THT-Leiterplattenbestückung

#Leiterplattenmontage