zuerst, check whether your PCB is high voltage. Allgemein gesagt, high voltage is defined as starting at 1000V.
Davon abgesehen, there is absolutely nothing wrong in general with using surface-mount parts in a device running at these voltages, so long as the parts you are using are rated for voltages you are using them at. Keep in mind as well that you do not need to make a single decision between SMT and through-hole parts. You can mix and match both within a single design.
#PCB-Design #PCB-Montage
It is important to learn how to clean a circuit board properly if you’re working…
When designing PCBs, selecting the appropriate type of holes for fasteners is crucial. And much…
PCB copper foil is one of the most critical materials in the printed circuit board…
Shenzhen, China - Februar 11, 2025 - MOKO-Technologie, a leading global electronics manufacturing service…
While most people focus on the components and copper traces that make up PCBs, there's…
The right type of PCB material can make or break the performance of your electronics project.…