Can I use a hot glue to cover a PCB board to insulate it and prevent it from damage?

I want to DIY PCB board at home, but raw material is limited. Can I hot glue to cover a PCB board? Is it advisable to do that?

pcb manufacturing
September 20, 2023

Not recommend. There are two proper methods to coat a PCB.

The first is via a conformal coating.
The other is potting epoxy.

Depending on your electronics casework, you may be able to fill with with non-conductive epoxy.
You have to be concerned about any cabling.
Once potted, your gear is unrepairable. You have to watch out for connectors.
If they will with epoxy, they won’t work any longer.
If the PCB is depending on cooling via the case, you can try heat-conducting, electrically insulating potting epoxy.

#PCB Manufacturing

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

How do surface mount components withstand heat of reflow while through hole components can not?

Some online tutorials about soldering TH components, like transistors and ICs, are delicate components and can be easily damaged by heat. When it comes to soldering surface mount IC and components, some prefer to use a reflow oven which heats up the them to a temperature above the melting point of solder. So why?

Oliver Smith December 8, 2023

What are possible solutions to PCB warpage problems?

My PCB manufacturer just informed me that he is facing PCB warpage issue in my simple, single sided, copper poured PCB. He says to avoid this issue he suggests to add a dummy copper patch by keeping 3mm copper clearance from all sides. Can somebody tell me what leads to this issue and what are possible solutions to this problem ?

Oliver Smith November 10, 2023

Are there any guidance on recommended package size and type for a surface mount linear regulator IC on my board that will be hand-soldered?

I am designing a board that needs a couple linear regulators (5.5v to 3v and 3v to 1.6v) but I am having difficulty selecting a suitable surface mount package type and size that will allow me to hand solder the IC to the PCB without too much difficulty.

Oliver Smith December 4, 2023