Technical Writer
Oliver is an experienced electronics engineer with over 7 years of experience developing products in IoT, consumer electronics, and medical devices. He is highly skilled in analog circuit design, embedded systems, PCB layout, firmware coding, and prototyping electronic products. Oliver’s expertise encompasses the full product development cycle, from concept to mass production. He holds a Master’s degree in Electrical Engineering and leverages his deep technical knowledge to deliver innovative electronic solutions.
My project have gone through from design, prototype to mass production after lots of discussion and adjustment. Now the manufacturer are making our products in their product lines. And I would like to know is there any differences between the prototypes in my hand now and the final products output by the manufacturer?
It is the first time I place a prototype order to a manufacturer for my research. And I want to know how a common prototype looks like.
Our team are developing a portable medical device with a small size, so we need a small PCB. How do I determine the traces width when designing a PCB? Actually we want it as narrow as possible to fit the device, is it OK?
I required a BOM from PCB designer of manufacturer, but he sent me a Gerber. How can I open and read it?
I want to DIY PCB board at home, but raw material is limited. Can I hot glue to cover a PCB board? Is it advisable to do that?
I am a project procurement. Recently, Our project is to develop a television. Of all the materials supply, PCB was the slowest one. And even our engineer took part in the discussion with PCB supplier to push them. Is it really hard to make a RF PCB?
My microwave is broken. Should I send it to maintenance or buy a new one? What factors should I consider in this case?
We are a home appliances company and now we plan to develop a microwave oven. PCB is the key part of the device and we know it is not a duck soup. What is the differences between microwave PCB and common PCB?
I received the price breakdown of PCB quotation from my suppliers. The tooling fee is not so pretty. What is this process and can we skip it to save the cost?
Markets
Resources
Contact Us
Copyright ©2024 MOKO Technology | Your Trusted EMS Partner 粤ICP备15085690号
