I am working on a project that uses small Bluetooth low energy (BLE) beacons to track important items. Is there…
There is a copper pour over the entire top of the my PCB, which is part of GND net. It…
A common question when designing complex printed circuit boards for advanced electronics is whether to use stacked or staggered vias…
I've typically used RF switches for this purpose, but that's also when it was necessary to allow the antenna selection…
PCB reverse engineering refers to the process of analyzing and understanding the design, layout, and functionality of a printed circuit…
I have a set of LED driving lights for motorcycle that must be wired through a ground-leg pulse width modulation…
I want to desolder a tiny surface mount button from the motherboard of a phone. There are a lot of…
In the design of a power electronic PCB, I want to use a metal PCB for heat dissipation of a…
The PCB has a pulse oximeter mounted on the surface, and it's tolerance is 0.6mm. The problem is the pulse…
I am designing a board that needs a couple linear regulators (5.5v to 3v and 3v to 1.6v) but I…