Which soldering iron tip should I use?

All of the soldering I've done to this point has been with through-hole components. I hope to move up to some smaller surface-mount parts at some point in the future. I've got a Weller WES51 soldering station. There is a large number of ET series tips available. How do I choose the right tip for the components I'll be working with?

December 13, 2023

You can, in fact, solder a 0.4mm pitch TQFP with a tip that spans several pins, such as the ETA you mention, but it takes a lot more skill and flux.If you’re doing mostly through-hole components, the ETA is perfectly fine.
I’m also doing SMT and very fine SMT work, so I also purchased the 0.030″ and 0.015″ conical tips. I use these under a microscope to do the 0.4mm (about 0.016″) pitch TQFP chips.
It is worthwhile getting the biggest chisel tip you can, as well, for the occasional need to deal with soldered heat sinks or parts soldered to ground planes or PCB heat sinks. These can pump all 40+ watts of your iron into the joint, allowing you to remove it without heating the component up too much.

Remark: Keep in mind that typical wet sponge tip cleaners can lower the tip’s temperature significantly, especially with the small tips.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Which soldering iron tip should I use?

Oliver Smith

Oliver Smith

What Others Are Asking

What is the use of thermal reliefs on vias for a copper pour?

Does a simple wire antenna need a 50 ohm transmission line?

How much clearance should you include in through-hole components holes?

Read Detailed Advice From Blog Articles