Does anyone have any experience using zero-ohm resistors in an RF signal path to select antennas?

I've typically used RF switches for this purpose, but that's also when it was necessary to allow the antenna selection to be changed "in the field". But for cases where the antenna selection is a manufacture-time option, I'm considering simple zero-ohm resistors.

I highly recommend using a normal SMD 10pF to 100pF ceramic capacitor, depending on frequency. They’re already used on the board, and tend to be cheaper than zero-ohm resistors, as we buy them by the bazillion rather than the handful.

Read More: Consumer Electronics

#PCB Design

Picture of Oliver Smith

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.
Picture of Oliver Smith

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

What Others Are Asking

Is aluminium foil a good substitute for kapon tape when soldering?

I want to desolder a tiny surface mount button from the motherboard of a phone. There are a lot of similarly tiny components surrounding it that I do not want to damage with heat from the soldering iron. Can I use aluminium foil in lieu of kapton tape to protect these components?

Read Detailed Advice From Blog Articles

Scroll to Top