How can I connect my small PCB with sensor to the bigger PCB?

My small PCB is mounting a very sensitive fragile sensor on the top surface that has to be wire bonded to the PCB, so I am trying to design a smaller PCB that can be surface mounted to the bigger PCB. How can I get some kind of thin footprint for interconnecting the two PCB boards?

December 4, 2023

You can just put plated half holes on the edge of the small board and then solder it directly to the large board. This skips having a connector all-together. Many board manufacturers can do this.

#PCB Design

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Why does the PCB manufacturer always ask for a change in your PCB design?

Many a time our PCBA manufacturer calls us about a problem of the design file. Sometimes we think it is time-consuming to discuss this issue. Just want to know why they always do that.

Oliver Smith September 19, 2023

How to find a datasheet for a part that doesn’t exist on the manufacturer’s website?

While bored recently, I decided to take apart a few old pieces of electronic equipment and attempt to reverse-engineer them. I’ve been doing pretty well, but I’ve come to an IC that I can identify but doesn’t seem to exist on the manufacturer’s website.

Oliver Smith October 24, 2023

Is aluminium foil a good substitute for kapon tape when soldering?

I want to desolder a tiny surface mount button from the motherboard of a phone. There are a lot of similarly tiny components surrounding it that I do not want to damage with heat from the soldering iron. Can I use aluminium foil in lieu of kapton tape to protect these components?

Oliver Smith December 5, 2023

How can I connect my small PCB with sensor to the bigger PCB?

Oliver Smith

Oliver Smith

What Others Are Asking

Why does the PCB manufacturer always ask for a change in your PCB design?

How to find a datasheet for a part that doesn’t exist on the manufacturer’s website?

Is aluminium foil a good substitute for kapon tape when soldering?

Read Detailed Advice From Blog Articles