We value your privacy

We use cookies to enhance your browsing experience, serve personalized ads or content, and analyze our traffic. By clicking "Accept All", you consent to our use of cookies. Read more in the Privacy Policy

Customize Consent Preferences

We use cookies to help you navigate efficiently and perform certain functions. You will find detailed information about all cookies under each consent category below.

The cookies that are categorized as "Necessary" are stored on your browser as they are essential for enabling the basic functionalities of the site. ... 

Always Active

Necessary cookies are required to enable the basic features of this site, such as providing secure log-in or adjusting your consent preferences. These cookies do not store any personally identifiable data.

No cookies to display.

Functional cookies help perform certain functionalities like sharing the content of the website on social media platforms, collecting feedback, and other third-party features.

No cookies to display.

Analytical cookies are used to understand how visitors interact with the website. These cookies help provide information on metrics such as the number of visitors, bounce rate, traffic source, etc.

No cookies to display.

Performance cookies are used to understand and analyze the key performance indexes of the website which helps in delivering a better user experience for the visitors.

No cookies to display.

Advertisement cookies are used to provide visitors with customized advertisements based on the pages you visited previously and to analyze the effectiveness of the ad campaigns.

No cookies to display.

How do you draw pin grid array in cadsoft Eagle PCB?

I'd like to use a processor that uses a pin grid array. Basically, I'd like to make the prototyping PCB board for it. I'm new to eagle. How can I connect the inner PGA pins to the header pins on the edge (without shorting the lines)?

Try not to make so long because your outer pinout is sensible. you should be able to do most of this on one layer. With a standard 5 mil trace/space process, you should have no problem fitting a trace between two pads. It should be possible to route that whole thing on one layer.

Read More: PCB Design Service

#PCB Design

Picture of Oliver Smith

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.
Picture of Oliver Smith

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

What Others Are Asking

Can I design SMD elements on the back of THT?

I’m designing a PCB right now and found out I can save a lot of space using the back of THT elements. Is it legit to design like that? Are there any problems that might occur? 

Oliver Smith November 24, 2023

Is aluminium foil a good substitute for kapon tape when soldering?

I want to desolder a tiny surface mount button from the motherboard of a phone. There are a lot of similarly tiny components surrounding it that I do not want to damage with heat from the soldering iron. Can I use aluminium foil in lieu of kapton tape to protect these components?

Oliver Smith December 5, 2023
Browse All Questions

Read Detailed Advice From Blog Articles

Read All Articles

Markets

PCB

Resources

Contact Us

Copyright ©2025 MOKO Technology | Your Trusted EMS Partner 粤ICP备15085690号

Facebook Twitter Linkedin Youtube