We value your privacy

We use cookies to enhance your browsing experience, serve personalized ads or content, and analyze our traffic. By clicking "Accept All", you consent to our use of cookies. Read more in the Privacy Policy

Customize Consent Preferences

We use cookies to help you navigate efficiently and perform certain functions. You will find detailed information about all cookies under each consent category below.

The cookies that are categorized as "Necessary" are stored on your browser as they are essential for enabling the basic functionalities of the site. ... 

Always Active

Necessary cookies are required to enable the basic features of this site, such as providing secure log-in or adjusting your consent preferences. These cookies do not store any personally identifiable data.

No cookies to display.

Functional cookies help perform certain functionalities like sharing the content of the website on social media platforms, collecting feedback, and other third-party features.

No cookies to display.

Analytical cookies are used to understand how visitors interact with the website. These cookies help provide information on metrics such as the number of visitors, bounce rate, traffic source, etc.

No cookies to display.

Performance cookies are used to understand and analyze the key performance indexes of the website which helps in delivering a better user experience for the visitors.

No cookies to display.

Advertisement cookies are used to provide visitors with customized advertisements based on the pages you visited previously and to analyze the effectiveness of the ad campaigns.

No cookies to display.

What are primary and secondary sides of PCB?

I am designing a 2 layer PCB with components on both side of it. SMT components are one one side of PCB, but TH (through hole) components are on both sides. I need to understanding something mentioned by the supplier called primary and secondary sides.

The primary side is the side that has most of the components, especially the ICs. The most common soldering technique these days is reflow soldering. It is simply easier to get precision temperature profiles on one side of the board only.

The secondary side can also support components, but

  1. it’s harder to control the temperature precisely, and
  2. gravity works against you as the solder paste begins to melt and the components on the underside of the board want to fall off.

Read More: Multilayer PCB

#PCB Assembly

Picture of Oliver Smith

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.
Picture of Oliver Smith

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

What Others Are Asking

How should I handle wet PCBs?

A batch of PCB got wet in warehouse due to roof linking. Too terrible to shoulder the lost. How can I do to rescue these wet PCBs? Or to minimize the damage?

Oliver Smith November 15, 2023
Browse All Questions

Read Detailed Advice From Blog Articles

Read All Articles

Markets

PCB

Resources

Contact Us

Copyright ©2025 MOKO Technology | Your Trusted EMS Partner 粤ICP备15085690号

Facebook Twitter Linkedin Youtube