How do you usually organize SMT parts during PCB assembly?

Suppose one is hand-assembling a board with many SMT components. Unlike THT, SMT components are often not labeled. How might one keep small (<100) quantities of such parts properly organized during assembly? Are there particular tools? Storage devices? Methods?

November 22, 2023

You can find SMT parts storage bins on online shopping platforms. They can be opened with tweezers and closed very easily. For example, you can arrange a few “trays” of them, where one is for capacitors, one is for resistors, etc.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

CEM3 or FR4 PCB, which is the lightest material?

There is nothing about weight in the substrate datasheets I found.
Between CEM-3 or FR4, which is the lightest material ? What is the average weight by surface for CEM-3 boards ?

Oliver Smith November 17, 2023

What equipment is used by professional PCB manufacturers?

This month we plan to find a proper suppliers to produce PCB for our new products, a healthcare watch. One of our supplier assessment items is about production equipment, which I know few about them. Can you share some common equipment which professional factory may use?

Oliver Smith September 19, 2023

Is paste mask layer, both top and bottom layer, necessary for THT components?

I know the paste mask layer is also called the stencil layer. It’s only used for assembly. I want to know if the paste mask layer (both top and bottom layer) is necessary for through hole components. For SMD components I know the paste mask layer is required to solder the components. Is it necessary for through hole components?

Oliver Smith November 27, 2023

How do you usually organize SMT parts during PCB assembly?

Oliver Smith

Oliver Smith

What Others Are Asking

CEM3 or FR4 PCB, which is the lightest material?

What equipment is used by professional PCB manufacturers?

Is paste mask layer, both top and bottom layer, necessary for THT components?

Read Detailed Advice From Blog Articles