Can we do wave solder the through hole parts without masking it?

We would like to do wave soldering for the through hole components. All through hole components are top side of PCB. Only test points, which require mask during process, are on the bottom side. So there is a extra labour cost at adding and removing the mask. Can we do wave solder the through hole parts without masking it?

November 21, 2023

You can ask the assembly house to put Kapton tape over the test pads if you’ve designed the PCB to make that easier.
You can get the board supplier to add peelable solder mask, but it will cost money.
You can just use the pogo pins on the solder-covered pads in most cases, maybe not for very low-level measurements, and even for those there are particularly aggressive pins available that have a drilling action.

#PCB Assembly

https://www.youtu.be/TXM9z0rBGhE?si=lJaT2Lfz1HAoQP-V

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Can we do wave solder the through hole parts without masking it?

Oliver Smith

Oliver Smith

What Others Are Asking

How can I make electrical connections over v-score line?

What type of silkscreen ink is used in PCB manufacturing?

What board can be used as foundation for building a power electronic converter?

Read Detailed Advice From Blog Articles