CEM3 or FR4 PCB, which is the lightest material?

There is nothing about weight in the substrate datasheets I found. Between CEM-3 or FR4, which is the lightest material ? What is the average weight by surface for CEM-3 boards ?

November 17, 2023

CEM-3 is lighter than FR4,the average weight is about 3.5KG/sqm. but now most of PCB manufacturers less use CEM-3 material to make PCB,almost use FR4 material.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

How can I separate PCB antenna and SMA connector?

I am designing a prototype PCB for a Lora node. It will have an SMA connector (J2) and a PCB antenna. Switching RF connectors are not available in my area, so as an amateur enthusiast what is a good way to separate the antennas?

Oliver Smith November 17, 2023

What are primary and secondary sides of PCB?

I am designing a 2 layer PCB with components on both side of it. SMT components are one one side of PCB, but TH (through hole) components are on both sides. I need to understanding something mentioned by the supplier called primary and secondary sides.

Oliver Smith November 23, 2023

Why are there teardrops on PCB pads?

I received the PCB design file from supplier. There are some teardrops, which I have seldom seen. Why are there teardrops on the PCB design?

Oliver Smith October 31, 2023

CEM3 or FR4 PCB, which is the lightest material?

Oliver Smith

Oliver Smith

What Others Are Asking

How can I separate PCB antenna and SMA connector?

What are primary and secondary sides of PCB?

Why are there teardrops on PCB pads?

Read Detailed Advice From Blog Articles