C for capacitance. R for resistance. CR for capacitive reactance circuit.
Alternating current can pass through the capacitor. When the capacitor is connected to the AC circuit, the charge on the capacitor plate has a hindering effect on the directional moving charge, which is called the capacitive reactance.
Read More: PCB Design and Layout Services
#PCB Assembly
If I want to design a PCB with as much noise immunity as possible, should I leave off test points? Can PCB test points be a source of noise?
I’m making a 4 layer PCB prototype that uses a bluetooth mcu connected to a 2.4GHz chip antenna. I’m thinking about what to do with the feedline, whether it should be buried on one of the middle layers, or left on the top layer. To get a 50 ohm line, should I choose top layer with 13-mil width or buried miccrostrip with 7-mild width?
I’m designing a new PCB where I have a whack of connectors that have to line up with the metalwork. There are some problematic connectors. All 4 pins are round. I want to have the holes as small as possible while allowing for good solder adhesion over the full length of the pin. I’m looking for guidance on how much clearance around the component lead I should have in order to get good solder wetting and adhesion.
Markets
Resources
Contact Us
Copyright ©2024 MOKO Technology | Your Trusted EMS Partner 粤ICP备15085690号
