I forgot a resistor on my PCB prototype – how do I add one in?

I need to add a resistor into a data line on my project. The data line is a trace and carries low speed data. A through-hole resistor will be fine. The pins for both ends of the trace are exposed, but how do I add the resistor and remove the trace?

October 26, 2023

If your PCB has a solder mask, you can fix this with an SMT resistor even when traces are close together. Cut the trace and scrape the solder mask away on both sides of the cut, over a few mm. Solder an 0603 or 0402 over the cut. If I patch like that, I actually make two cuts a mm apart, and remove the trace by dental pick between both cuts to make sure there’s a decent interruption of the trace.
Alternatively, you can do the same and solder a PTH resistor, whose wires you first bent so that they lay flat on the trace. Won’t probably work as well on narrow traces, like 0.5mm.

#PCB Assembly

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Can I design SMD elements on the back of THT?

I’m designing a PCB right now and found out I can save a lot of space using the back of THT elements. Is it legit to design like that? Are there any problems that might occur?

Oliver Smith November 24, 2023

How can I connect my small PCB with sensor to the bigger PCB?

My small PCB is mounting a very sensitive fragile sensor on the top surface that has to be wire bonded to the PCB, so I am trying to design a smaller PCB that can be surface mounted to the bigger PCB. How can I get some kind of thin footprint for interconnecting the two PCB boards?

Oliver Smith December 4, 2023

What’s the thickness of FR4 substrate that one should take when designing a micro-strip antenna with an HFSS tool?

I am designing a micro-strip antenna with an HFSS toll, what’s the thickness of FR4 substrate that one should take ?

Oliver Smith October 27, 2023

I forgot a resistor on my PCB prototype – how do I add one in?

Oliver Smith

Oliver Smith

What Others Are Asking

Can I design SMD elements on the back of THT?

How can I connect my small PCB with sensor to the bigger PCB?

What’s the thickness of FR4 substrate that one should take when designing a micro-strip antenna with an HFSS tool?

Read Detailed Advice From Blog Articles