Can I make a PCB without a ground plane?

Recently we are developing a portable device which should be very tiny and light. In terms of PCB design, I am thinking whether it is a good idea to exclude ground plane to minimize the product size.

September 25, 2023

It depends. For high-speed logic or RF circuits, a ground plane is necessary. For others, ground or power plane is not required.

You should, however,

Make sure that the traces are as wide as possible, particularly for the power, ground or other high-current connections.
Ensure fatter traces are more reliable.

#PCB Design

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Is via-in-pad bad for manufacturing?（thru-hole hollow-centre via）

I see some videos online that shows via-in-pad during manufacturing. But I don’t think it is a good way, is it?

Oliver Smith September 25, 2023

How to handle feedline of bluetooth PCB connected to a 2.4GHz chip antenna?

I’m making a 4 layer PCB prototype that uses a bluetooth mcu connected to a 2.4GHz chip antenna. I’m thinking about what to do with the feedline, whether it should be buried on one of the middle layers, or left on the top layer. To get a 50 ohm line, should I choose top layer with 13-mil width or buried miccrostrip with 7-mild width?

Oliver Smith November 30, 2023

What will be the role of a copper layer in a metal core PCB in thermal dissipation?

In the design of a power electronic PCB, I want to use a metal PCB for heat dissipation of a TO-220 package MOSFET. To do that I want to mount metal PCB on the MOSFET with the use of thermal paste and screw exactly like we do when we use heatsink for the same package. Should I leave the copper of PCB between MOSFET surface and dielectric of PCB or remove the copper surface and leave only the dielectric opening?

Oliver Smith December 5, 2023

Can I make a PCB without a ground plane?

Oliver Smith

Oliver Smith

What Others Are Asking

Is via-in-pad bad for manufacturing?（thru-hole hollow-centre via）

How to handle feedline of bluetooth PCB connected to a 2.4GHz chip antenna?

What will be the role of a copper layer in a metal core PCB in thermal dissipation?

Read Detailed Advice From Blog Articles