Welcome to MOKO Technology Limited

Skype: bruseguo
contact us 86-75523573370
+86-15889772429
Email us: bruse@mokotechnology.com.cn

Hot News

Phone:

86-75523573370

Email: bruse@mokotechnology.com.cn

Fax:86-75523573370-803

Address: 4F,Buidling2,Guanghui Technology Park,MinQing Rd,Longhua,SZ 518109,China

Current Position:Home » PCB Capabilities » PCB » HF PCB Manufacturing, High Frequency Printed Circuit Boards
HF PCB Manufacturing, High Frequency Printed Circuit Boards
prevnext

HF PCB Manufacturing, High Frequency Printed Circuit Boards

  • Introduction:MOKO can be your go to source for high frequency PCB with Rogers material from Rogers Corporation, a leading name in PCB technology.
  • Hotline:86-75523573370
  • Detail

HF PCB Manufacturing, High Frequency Printed Circuit Boards Services at MOKO

Nowadays, electronic devices with high frequency is the developing tendency , The increasing complexity of electronic components and switches continually requires faster signal flow rates, and thus higher transmission frequencies. Thus developing new products always need to use high frequency substrate, satellite system, mobile telephone receiving base station and so on, these communication products must use high frequency PCB.

Do you need a PCB that incorporates a special signal requirement? Our high-frequency PCBs may be just what you're looking for. The frequency of high-frequency printed circuit boards is typically around 500MHz ~ 2GHz. Special materials are required to achieve a high frequency, such as Rogers, PTFE. The changes in the Er value of these materials can affect the impedance of the circuit board. In addition to determining the correct the value of the Er, designers also have to take other parameters into consideration, like conductor width and spacing, substrate constant, etc. These parameters must be exactly specified and implemented with the highest level of process control. 


The features of HF
Printed Circuit Boards below:

1. DK should be small and stable enough, usually the smaller the better, high DK may lead to signal transmission delay.

2. DF should be small, which mainly affect quality of signal transmission, the smaller DF could make smaller signal wastage accordingly.

3. The thermal expansivity should be the same with copper foil as much as possible, because the difference will lead to copper foil separated in the changes of cold and heat.

4. Water absorptivity must be low, high water absorptivity will affect DK and DF when in the wet environment.

5. Heat resisting property, chemistry resisting, impact endurance, peel off resisting must be good.

MOKO Makes it Easy to Design HF PCBs

MOKO supply know-how, all popular materials high frequency PCB include Rogers, Taconic, Arlon etc, for several types of high frequency substrates- reliably even for complex requirements , we have sufficient storage to ensure fast delivery.


If you have any requirement for high-frequency PCB options which are not listed in our online quotation form, please send a quote request along with your design file to bruse@mokotechnology.com.cn , we will get back to you with a custom quote accordingly.


  • Contact Us

MOKO Technology Limited

Phone:86-75523573370

Fax:86-75523573370-803

Email:bruse@mokotechnology.com.cn

Address:4F,Buidling2,Guanghui Technology Park,MinQing Rd,Longhua,SZ 518109,China




* RequirePurchase:HF PCB Manufacturing, High Frequency Printed Circuit Boards